Electronics Musical Instrument ( Piano) – SCOPES Digital Fabrication

Lesson Details

Grade Levels
6-8
Fab Tools
Standards
Author

You need to login or register to bookmark/favorite this content.

Author

Supriya Kadam
Supriya Kadam
Other
Hiii,I am Supriya Kadam. I have done Electronics engineering and then fab academy deploma. Reading books,writing poems,talking with different people,tracking are my hobbies. After my graduation I have started working with Vigyan Ashram and now I am working here as… Read More

Summary

We are use piano in our traditional event which has plastic button. After pressing button we can hear sound of swaras ( SA,RE,GA,MA,PA,DHA,NI,SA) instead of this type of piano we can use touch sensor instead of button.

 

What You'll Need

Sr.no. Material Quantity

1. Arduino Mega 1

2. 47 K resistor 7

3. Copper foil half sheet

4. Connecting wire 3mtr

5. Speaker 1

6. Laser cutting Box 1

Lesson Materials

The Instructions

Take copper foil and printed 7 swaras sketch.

First take copper foil and printed sketch paper of 7 swaras (Sa, Re,Ga,Ma,Pa,Dha,Ni). Cut copper foil as size of sketch and paste it on sketch paper.

Tell them how to sketch 7 swaras.

Take 47K ( yellow, violet, orange ) resistor.

Solder two different wire(red and black) to each terminal of resistor using soldering gun and soldering material .

Introduce them with how to solder.

Soldering of 7 swaras resistor terminal.

Solder first terminal of each 7 swaras resistor( of red wire ) with copper foil and also solder second terminal of resistor (of black wire) to each analog pin of arduino mega board respectively.

Help them soldering to copper foil and arduino mega.

Then solder all red wire of each swaras to 5v pin of Arduino mega board. Also connect Speaker.

Combine all red wire of each swaras and make only one single wire. now connect single red wire to 5v pin of arduino.

After all connection using voltage divider concept , please upload code into arduino mega board by using arduino software.

Make program of Piano in arduino software and upload code into arduino board.

Introduce them with arduino software.

Test the Piano by putting our finger on copper foil.

When we put our finger on each copper foil then circuit get ground and complete it. Then we hear sound of 7 swaras (Sa,Re,Ga,Ma,Pa,Dha,Ni) respectively.

Introduce them with how circuit complete.

Standards

  • (Fab-Programming.2): I can create a program with more than one instruction.
  • (Fab-Fabrication.2): I can develop workflows across four or more of the following: modeling softwares, programming environments, fabrication machines, electronic components, material choices, or assembly operations.

Lesson Feedback

One Response

  1. SCOPES-DF March 8, 2019
Load More

Rating
Sending